Tap and shower specialist Hansgrohe is a company steeped in tradition. Incidentally, the Hansgrohe Group comprises the brands “hansgrohe” and “AXOR”. During the 2016 financial year, Hansgrohe employed around 4,800 people and supplied products to more than 140 countries. This is on a quick clip connector so you will hear a clip when it's pushed on.With 34 companies and 21 sales offices all over the world, Hansgrohe is one of the few global players in the sanitation industry. The flow control handle has got a mark at the top in the middle to mark the off position, so the marking goes at 12 o'clock. Lightly Grease the O-rings of the sleeve and press onto the housing and against the tiles. Sometimes the safety stop point on the handle is at the top so the safety stop sleeve has to go at 12 o'clock so that the button corresponds with this part. On this particular model the safety stop point is at the bottom at 6 O'clock, and the button is on the underside of the handle so this safety stop point goes at 6 o'clock. Then the safety stop sleeve, be mindful of the orientation that this goes onto the thermostat housing. To reinstall the finish set, face plate, handles and to set the thermostat temperature first you need to screw on the decorative shroud that simply goes over the flow control and screws into position. When tightening them you just want to gently nip the securing to the tiles. With the securing ring use silicone grease on the Nylon threads then tighten the screws being careful not to cross thread. Before installing the brass block back make sure that all of the O-rings are in place, then screw all 4 screws tightly. To replace a non-return valve, use a small flat headed screwdriver and put it just inside and to the side wall, you can edge a non-return valve out and to replace it simply press it back into its housing. You can check the operation of the non-return valve and remove any debris by pressing the plungers. Then remove the brass bock by unscrewing the bolts giving you access to the non-return valves. Remove the screws and pull off the housing ring. To gain access to the non-return valves you first need to remove the faceplate housing ring it is held in by 4 nylon screws. Make sure the pins are located correctly, then close the back nut on and screw in tightly. On the back of the cartridge are to locating pins which marry up to the two holes inside the brass body, so that it is in its correct orientation. The whole cartridge will come out in one barrel, if you ever need to replace the cartridge unscrew the extension spline off the old one and install it onto the new one using an allen key. To remove the flow control cartridge you must unscrew the sleeve by loosening the back nut that holds the cartridge in place. It is a good idea to remember the orientation of the safety stop point. To remove the thermostat, first you must remove the safety stop sleeve. It is always good practice to remove the handle at the same place that you want to put it back on when you have finished the service. If there is no hole, then it is on a quick click connector. There are two different ways that this can be fixed, If there is a hole on the handle, then there is a grub screw which you simply loosen and the handle will come off. Identify how the handle is fixed to the splines of the iBox.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |